SecurityMan DVR-04 Guía de instalación descargar pdf (Pagina 61)

Chapter 3: First-Time NT500 Offline System Installation & Setup

3 – 43

NotesA message appears stating, "Events collection progress

(100%)".

6 Click OK.

The event history is transferred from the lock to the Stan-

ley NT500 application.

To reset the diagnostic code

1 Repeat Steps 1-6 from above (To transfer event history

from the lock to Stanley NT500).

2 On the Details tab, click Tasks, then Reset diagnostic code.

The diagnostic code is reset and a message appears stat-

ing, "Diagnostic code reset for controller."

3 Click OK.

To disconnect from the lock

When you are finished performing tasks at the lock, do the fol-

lowing:

1 Click Tasks, then Disconnect from Controller.

A message appears stating, "Successfully disconnected

from controller."

2 Click OK.

3 To disconnect the laptop from the lock, press the button

on the programming cable connector and unplug the

programming cable from the lock's communication port.

Configuring an office admin kit as an enrollment station

With NT500 you have the flexibility to use an office admin kit

(admin reader) to assign cards to cardholders. An office

admin kit can be connected to a controller via PC interface.

This reader can then be used to assign cards to cardholders.

To configure the admin reader as an encoder

1 From the main menu, select Tools > Configure Peripherals.

The Configure Peripherals window appears.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 73 74

Sin comentarios

SecurityMan DVR-04 Guía de instalación Pagina 61